Slide out, drive/motor location

[GraftonGuns]

Hi All,
So I am looking for a schematic that shows exactly where the slide out motors/drives are located for my particular unit as I don't want to hack apart the coroplast in the event that I have a slide out failure. 2017 Eagle HT 27.5 RLTS. Thank You in advance.
Paul:

[JohnWedell]

If you are talking about the through the frame slide out the motor is underneath on the opposite side of the slide out and there is usually a access cover usually 18 to 24 in square that if you open it up the motor is in there. If it’s a cable slide the motor is on top inside in the middle of the front of the slide out behind the facia. That’s all I know hope it helps

[GHen]

If it’s schwintec, with the rails on the outside/sides of the slideout, the motor is between the wall and the slideout at the top of the side opening. Pull the rubber side seal back and you can see it.

[bill3kirk]

Having just replaced one of these for another camper the Schwintek on the slim rack is located at the top of each corner and is accessible from the inside when retracted or outside when extended. Their unit was a Winnebago Vista but the same setup as the kitchen slide in the 377. Removing the motor was straight forward after removing the rubber trim to gain full access. There is either a retaining spring that is lifted up off a hook or a set screw. Removing and putting a new ($549.00) motor in excluding the trim work took about 10 minutes tops.

The Lippert site has good manuals and their tech support was good.