Another suggestion
I also filed the flats down slightly so it wasnt so tight. I then used a lenghth of small (maybe 16 ga) insulated electrical wire, and looped it around the outside diameter of the hose, just behind the coupling, and left enough about a 6" length for a "handle"( I used a butt joint connector to connect the two ends of the wire). Now I put the sewer hose in the bumper and push it back a few inches from the cap. When it's time to pull it out again, I grab the wiring to pull it out. Makes it easier to pull out.
__________________
2012 Chevrolet Silverado 2500HD - 6.0 Liter gasser - 4.10 gears - Blackbear Performance Tuned.
2012 Jayco Jayflight 32BHDS
|