|
01-03-2019, 08:46 PM
|
#1
|
Junior Member
Join Date: Nov 2018
Location: High Ridge
Posts: 13
|
Travel Trailer Hitch
Has anyone installed a travel trailer hitch such as curt to the back of their travel trailer? Not to the rear bumper but to the underneath of the trailer?
I have a 2019 Jayco 195RB and wanting to purchase a Honda inverter generator. Would like to mount a Curt Hitch and attach a cargo carrier. Has anyone done this?
__________________
2019 Jayco Jay Flight SLX 7 195RB w/Equalizer hitch
2017 Honda Pilot Elite w/ATF cooler, w/electronic brake
|
|
|
01-03-2019, 09:14 PM
|
#2
|
Senior Member
Join Date: May 2012
Location: Minnesota
Posts: 9,782
|
Yes! I have a hitch welded to the frame.
My recommendation is to locate a local welding shop and have them reinforced the frame at the mounting location.
|
|
|
01-03-2019, 09:50 PM
|
#3
|
Member
Join Date: Jul 2017
Location: DeForest
Posts: 40
|
What I did to my previous trailer, a Palomino Puma, was purchase a receiver tube on Amazon that was long enough to reach under the trailer so I could use two cross members of the frame as support. Then I took it to a welding shop and they manufactured supports that went under the tube and bolted to the cross members. I also used similar supports with bolts inside the square tube bumper for a third area of attachment.
I don't know if this is a possible with your trailer as I am not familiar with it but it was very solid on this trailer.
The picture is the only one I could find. If you look close you can see the rearmost support and the bumper support. There is a third about 8 inches further under the trailer.
|
|
|
01-03-2019, 11:54 PM
|
#4
|
Senior Member
Join Date: Aug 2013
Location: Utah
Posts: 892
|
__________________
2014 Ram 2500 Mega Cab Laramie 4x4 6.4L HEMI 4.10s with antispin
2014 Jayco Jay Flight Swift 287BHBE
Equal-i-zer 90-00-1200(new 90-02-4900 shank)
2x Honda 2K
|
|
|
01-04-2019, 09:04 AM
|
#5
|
Senior Member
Join Date: Jun 2018
Location: Whitesburg
Posts: 685
|
I had this one welded on my 2018 264BH it is perfect. One thing to note is the frame on my camper was off set to one side so you have to adjust the hitch to sit a little further one side than the other to make it look centered with the back of the camper.
https://www.etrailer.com/RV-and-Camp...35-946403.html
|
|
|
01-04-2019, 08:48 PM
|
#6
|
Junior Member
Join Date: Nov 2018
Location: High Ridge
Posts: 13
|
Thanks for all the replies. I am however looking for someone that has had this installed on a 2019 Jay Flight SLX7 195RB
Thanks
__________________
2019 Jayco Jay Flight SLX 7 195RB w/Equalizer hitch
2017 Honda Pilot Elite w/ATF cooler, w/electronic brake
|
|
|
01-05-2019, 08:29 AM
|
#7
|
Senior Member
Join Date: Nov 2015
Location: Maine
Posts: 2,626
|
Quote:
Originally Posted by CamperTim
Thanks for all the replies. I am however looking for someone that has had this installed on a 2019 Jay Flight SLX7 195RB
Thanks
|
Frankly I wouldn't even think of it.. The 195 has very little cargo weight available.. About 200 lb after you fill the water tanks.
The danger in overloading is that if you hit bad road start bouncing you may bend an axle.. The axle. Been there done that. Of course you could install a heavier axle. I understand you don't want the genny in your tow vehicle. We have a Ridgeline and we can put it in the back without being exposed to fumes
__________________
2021 GMC Canyon
2021 Jayco 212QB
WDH ; Anderson
2012 Honda Ridgeline not towing anymore
2016 195 RB traded in
|
|
|
01-05-2019, 12:44 PM
|
#8
|
Junior Member
Join Date: Nov 2018
Location: High Ridge
Posts: 13
|
Quote:
Originally Posted by Kim Gass
Frankly I wouldn't even think of it.. The 195 has very little cargo weight available.. About 200 lb after you fill the water tanks.
The danger in overloading is that if you hit bad road start bouncing you may bend an axle.. The axle. Been there done that. Of course you could install a heavier axle. I understand you don't want the genny in your tow vehicle. We have a Ridgeline and we can put it in the back without being exposed to fumes
|
We travel with a Gunner Kennel in the back of our Honda Pilot. So the only place we can carry a generator is behind the TT.
__________________
2019 Jayco Jay Flight SLX 7 195RB w/Equalizer hitch
2017 Honda Pilot Elite w/ATF cooler, w/electronic brake
|
|
|
01-05-2019, 02:29 PM
|
#9
|
Senior Member
Join Date: Jul 2018
Location: Live Oak
Posts: 113
|
Quote:
Originally Posted by CamperTim
We travel with a Gunner Kennel in the back of our Honda Pilot. So the only place we can carry a generator is behind the TT.
|
What size generator? Could you use one of these instead?
Stromberg Carlson CC-255 Trailer Tray https://www.amazon.com/dp/B00U8AXRPW..._OnrmCbY9TZMPF
We haul 2 Gunner Kennels in the truck bed to keep our dogs safe when traveling so I know your pain.
|
|
|
01-05-2019, 02:42 PM
|
#10
|
Junior Member
Join Date: Nov 2018
Location: High Ridge
Posts: 13
|
Quote:
Originally Posted by ASTMedic
|
Honda EU3000IS Could not lift it that high
Tim
__________________
2019 Jayco Jay Flight SLX 7 195RB w/Equalizer hitch
2017 Honda Pilot Elite w/ATF cooler, w/electronic brake
|
|
|
01-05-2019, 03:23 PM
|
#11
|
Senior Member
Join Date: Aug 2013
Location: Utah
Posts: 892
|
Quote:
Originally Posted by CamperTim
Honda EU3000IS Could not lift it that high
Tim
|
What is your tow vehicle?
That tray and a 3000i would add over 200lbs to your tongue weight, and is still adding it to the trailer weight.
__________________
2014 Ram 2500 Mega Cab Laramie 4x4 6.4L HEMI 4.10s with antispin
2014 Jayco Jay Flight Swift 287BHBE
Equal-i-zer 90-00-1200(new 90-02-4900 shank)
2x Honda 2K
|
|
|
01-05-2019, 04:40 PM
|
#12
|
Senior Member
Join Date: Nov 2015
Location: Maine
Posts: 2,626
|
Quote:
Originally Posted by NewBlackDak
What is your tow vehicle?
That tray and a 3000i would add over 200lbs to your tongue weight, and is still adding it to the trailer weight.
|
That's the problem and one reason we tried 2000 at first ( we had no idea if it would be enough for us). Over three years it has been.. It may not be for the OP. Lugging 46 lb units was manageable.. Not so more.
I'm plumb out of ideas. While the 195 has been a perfect fit for us we have minimal stuff as cargo coming from a tenting and backpacking background. And there are only two of us
__________________
2021 GMC Canyon
2021 Jayco 212QB
WDH ; Anderson
2012 Honda Ridgeline not towing anymore
2016 195 RB traded in
|
|
|
01-23-2019, 10:00 AM
|
#13
|
Senior Member
Join Date: Mar 2013
Posts: 100
|
My wife and I lift a big heavy 4000 watt generac onto the trailer tray, a 3000 should be easy. We have it bolted down and locked, so we don't move it much, regardless. For us it puts the weight in a pretty good spot.
__________________
2016 Jayco White Hawk 32DSBH pulled by 2014 Chevy
Express 3500
Gone-2013 Keystone Bullet 294BHS
Gone-2007 National SurfSide 34DE
Gone-2006 ForestRiver Sunseeker 2900LTD
Gone-1994 Fleetwood PaceArrow
Gone-1978 Kit RoadRanger
|
|
|
01-23-2019, 12:44 PM
|
#14
|
Member
Join Date: Sep 2017
Location: Burns Harbor, RV Capital of the World
Posts: 72
|
Think Warranty
Quote:
Originally Posted by CamperTim
Has anyone installed a travel trailer hitch such as curt to the back of their travel trailer? Not to the rear bumper but to the underneath of the trailer?
I have a 2019 Jayco 195RB and wanting to purchase a Honda inverter generator. Would like to mount a Curt Hitch and attach a cargo carrier. Has anyone done this?
|
While attaching a receiver to the frame "may not" void the warranty, subsequent damage to the frame caused by receiver most likely will. It may be advisable to contact Lippert and consult with them. This is what I would tell my RV customers. Just because you "can" do it, doesn't mean you should.
__________________
Scott
NW Indiana
RV Capital of the World
|
|
|
01-23-2019, 12:55 PM
|
#15
|
Senior Member
Join Date: Jun 2018
Location: Whitesburg
Posts: 685
|
Quote:
Originally Posted by sbarlag
While attaching a receiver to the frame "may not" void the warranty, subsequent damage to the frame caused by receiver most likely will. It may be advisable to contact Lippert and consult with them. This is what I would tell my RV customers. Just because you "can" do it, doesn't mean you should.
|
IMO the campers should came factory with a receiver hitch. and a ladder.
neither of witch where on my 2018 264BH.
|
|
|
01-23-2019, 09:17 PM
|
#16
|
Senior Member
Join Date: Nov 2015
Location: Maine
Posts: 2,626
|
Quote:
Originally Posted by ggilbert
IMO the campers should came factory with a receiver hitch. and a ladder.
neither of witch where on my 2018 264BH.
|
We are talking about a much smaller trailer. No matter how you dice it in a 195 cargo weight is a concern as there is almost no room for a payload. There is about 200 lbs free with a full water tank or full waste tanks. Now if the OP were not to have any food bedding or clothes there might be room for the genny.
IMO neither can you or should you attach the cargo receiver to carry the genny.. Also be advised that the back of the unit gets really grimed up as there are no mudflaps Personally I would not want to subject the generator to road sand and ice and salt.
__________________
2021 GMC Canyon
2021 Jayco 212QB
WDH ; Anderson
2012 Honda Ridgeline not towing anymore
2016 195 RB traded in
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|