Another roof question?
So installed the MaxAir II cover above the bathroom vent on my 26BH today, and as my luck would have it the factory seal was a bit thick to allow me to install evenly. So i cleaned and removed the sealant around the vent to allow for the installation. I then installed the brackets and cover, and resealed around them to ensure there were no leaks, and then let bake in the Texas sun for a few hours. When i came back this evening to check on the seal, i noticed that the rubber membrane around the brackets had bubbled a little. Like the brackets had pulled the rubber up a little. I checked my sealant and it is all good, but I was wondering if this is something I should be concerned about? It is only around the brackets where is added new sealant?
__________________
2012 Dodge Ram Hemi 3.55
2012 Jayco Jay Flight 26BH
Reese Pro Series WDH w/ sway control 1000#
|