Jayco 12HW exhaust fan

[dhulls]

Hello, I have a new to me 20015 Jayco 12HW. I can't figure out how to turn on the ventline exhaust fan. There is power to the lights, but no power to the ventline fan. I don't see a switch anywhere. Where does the fan get its power from? Thanks

[Kholloway1998]

If there is no switch check to see if it's tied in with your GFCI. Reset the GFCI on your outlet . This outlet is commonly found in the bathroom.

[dhulls]

I tried resetting the GFCI, still not working. There is no power on the wiring to the fan. Anywhere else I should be looking?

[Kholloway1998]

Just not sure. Mine was not working either & the direction I gave you fixed my problem and hoped it would yours. At this point I would prolly remove the fan and inspect the wiring. Replace if need be. It's not a hard job just make sure you get a good seal on your gasket when reinstalling.

[dhulls]

Thanks for the input. I tested the fan by making a jumper wire and got power from the light that is next to the fan and it works fine. I will probably make that permanent so the fan will work when the light switch is on. Thinking there must be a blown fuse somewhere maybe?