Lift springs and tracks rusted
I recently purchased a Jayco 8’ truck camper. The lifts are froze in down position! I have sprayed PB Blaster down the shaft around outside and inside the post. Waiting to see if that works. After removing the stove and inverter I was able to get access to the crank area and under the sink where the pull cable attaches to the four corners. The crank had pulled two back screws up from the floor and two from the back wall! Fabricating a plate to attach to crank.
My question is this, how is the cable attached to the spring? I see how the cable is feeding back down the track. I assume welded?
I have not removed anything but the. Crank.
Wondering if I use something to tap on the end off the spring in the track to nudge it to move ?
Any input is appreciated
|