Forum: General Jayco RV Chat
09-03-2022, 11:17 PM
|
Replies: 25
Views: 5,170
Kinda of fortunate we actually have both a...
Kinda of fortunate we actually have both a 355mbqs and a new to us 30’ Thor ACE class A. Have been thru them all now from a tent trailer, tt, truck camper, fifth wheels and now a Motorhome. Went...
|
Forum: Jayco Class C Motorhomes
06-08-2022, 12:20 PM
|
Replies: 23
Views: 4,289
|
Forum: Jayco Fifth Wheels
01-06-2020, 08:04 AM
|
Replies: 10
Views: 2,481
I had a eagle a few years back and added a...
I had a eagle a few years back and added a universal motor home hitch. Drilled 4 holes in the frame bolted it up and good to go. Felt much better with that than the factory hitch that I have on my...
|
Forum: Jayco Fifth Wheels
12-09-2019, 08:48 PM
|
Replies: 5
Views: 1,576
|
Forum: Jayco Fifth Wheels
09-09-2019, 05:10 PM
|
Replies: 5
Views: 868
|
Forum: Jayco Fifth Wheels
09-09-2019, 08:20 AM
|
Replies: 5
Views: 868
355mbqs kitchen slide wall
Just a question, how much flex of the main interior wall do people get slide in vs out? Reason I ask is I have a gap between my cabinets on the inside wall when the slide is out of about 1/8 to 3/16...
|
Forum: Jayco Fifth Wheels
01-18-2019, 06:29 PM
|
Replies: 1
Views: 919
|
Forum: Jayco Fifth Wheels
01-09-2019, 11:06 PM
|
Replies: 0
Views: 743
Solar Panels and Wiring
I have 300 Watts of solar on my 355 already got a great deal on a additional 150watt panel. My question is what gauge of wiring would be needed for 450 watts or approx 27amps less power loss? I have...
|
Forum: General Jayco RV Chat
10-03-2018, 09:44 PM
|
Replies: 30
Views: 7,897
|
Forum: Jayco Fifth Wheels
09-22-2018, 09:57 PM
|
Replies: 3
Views: 771
|
Forum: General Jayco RV Chat
08-26-2018, 05:35 PM
|
Replies: 67
Views: 12,091
Mine is having to back my 355 out of customs...
Mine is having to back my 355 out of customs after I was told the clearance was a “hard” 13’4. Three customs agents had clear a line of 10 cars out behind me. Oops. Was told if I had even flintched...
|
Forum: Jayco Fifth Wheels
08-14-2018, 08:56 PM
|
Replies: 9
Views: 3,952
I have a eagle 355. Has the rear receiver for...
I have a eagle 355. Has the rear receiver for accessory. Looked at the Eagle HT that had the actual towing hitch. In 2015/2016 the receiver brackets and welds (lengths) were the same for both only...
|
Forum: Jayco Fifth Wheels
08-13-2018, 10:28 PM
|
Replies: 0
Views: 1,082
Generator Prep question
Have a 355mbqs and found a great deal on a onan on board gas generator. I have the transfer switch already installed for my inverter. My trailer doesn’t have the prep kit so looking for a fuel tank,...
|
Forum: Jayco Fifth Wheels
08-07-2018, 10:46 PM
|
Replies: 5
Views: 1,089
|
Forum: Jayco Fifth Wheels
07-16-2018, 10:12 PM
|
Replies: 20
Views: 5,654
Figured I would give one last update. After...
Figured I would give one last update. After fixing the bent roller bolt and adding a piece of .024” sheet metal to the underside of the slide where the roller bracket was dragging, I put some Teflon...
|
Forum: Jayco Fifth Wheels
07-11-2018, 02:02 PM
|
Replies: 18
Views: 6,848
Keep it level when putting slides out. Mine was...
Keep it level when putting slides out. Mine was great for 2.5 years and then off level (3”) side to side. Only time off level that amount and two bent outriggers and a bent roller bolt. Tore up the...
|
Forum: Jayco Fifth Wheels
07-11-2018, 12:20 PM
|
Replies: 3
Views: 882
|
Forum: Jayco Fifth Wheels
07-11-2018, 12:02 PM
|
Replies: 3
Views: 882
|
Forum: Jayco Fifth Wheels
07-08-2018, 08:54 PM
|
Replies: 3
Views: 882
|
Forum: Jayco Fifth Wheels
07-08-2018, 07:57 PM
|
Replies: 3
Views: 882
In wall slide roller - fixes
So when my outrigger bent it looks like it took one of the rollers with it, looks like the shaft most bent as the front metal edge is now gouging the floor up. Figure I can take a jack from the...
|
Forum: Jayco Fifth Wheels
07-08-2018, 07:48 PM
|
Replies: 20
Views: 5,654
|
Forum: Jayco Fifth Wheels
07-08-2018, 07:54 AM
|
Replies: 20
Views: 5,654
I think the late 2016 and beyond had the z...
I think the late 2016 and beyond had the z profile outrigger. Have heard they bend as well just not as bad. If I had them on mine I would still put the plates. As for the plates goon do that...
|
Forum: Jayco Fifth Wheels
07-07-2018, 09:32 AM
|
Replies: 20
Views: 5,654
|
Forum: Jayco Fifth Wheels
07-04-2018, 08:55 AM
|
Replies: 20
Views: 5,654
|
Forum: Jayco Fifth Wheels
07-04-2018, 07:54 AM
|
Replies: 20
Views: 5,654
Thanks anyhow. Oddly enough I think mine bent...
Thanks anyhow. Oddly enough I think mine bent this past weekend. Did a quick overnight on a unlevel spot 2 to 3 “ off side to side low on kitchen side. I’m always under the trailer for stuff first...
|