The front lip of the shower pan slightly tilts downward which is encouraging the water to leak forward. Trying to figure out how to lift that front (curtain side) part of the shower pan up a quarter of an inch.
It’s interesting, the pan itself is solid and level. It is as if they tightened down the lip too tight in the front which is pulling the front lip downward....
So net net, just trying to angle the front lip up and tilt back so water flows back into pan...
Anyone have any ideas on how to do this without disassembling? I was thinking about trying to insert a 1/4 thick strip of wood under the lip but have a feeling it is glued to the wood that is there...
Linear Mode
